What To Do After Upgrading Internet Speed? Brief Guide

Let’s start with today’s discussion on What To Do After Upgrading Internet Speed? Your video stream may temporarily pause for buffering if your wifi connection is too weak. When you live in a fast-paced, always-on environment, even the smallest inconveniences can soon accumulate and become annoying roadblocks to your daily tasks at work, school, or anywhere else.

Why don’t you consider increasing the speed of your internet connection? Are you satisfied with the results or not? If not, here’s how to get it back to where it should be.

What To Do After Upgrading Internet Speed?

You should restart your network, so unplug your modem and router and wait a while. Reconnect your modem, wait for internet access through the modem, and then reconnect your router.

Restart Your Router

If you have a separate router, follow the same steps. Power cycling your router clears its memory and provides it a fresh start on tasks that were previously taking up too much of its resources. Finally, turn off your wireless devices’ wifi connections. Turn wifi back on after a few seconds. Check to see if your connection improves after allowing these devices to reconnect.

Turning your home network equipment off and back on may seem like a simple task, but it can greatly impact your network’s performance. At the very least, you should do a system reboot once or twice a year. While restarting your equipment can be done at any moment, consider that doing so will leave you without an internet connection for a few minutes.

Restart Your Modem

Wait 30 seconds before plugging in your modem or wireless gateway. The modem’s virtual mind can be cleared in this manner. Using your modem, you can communicate with your internet service provider from your home network.

One of the first steps in troubleshooting your internet connection is to perform a power cycle. However, you may require the assistance of a customer service representative to remotely reset your modem and ensure that it is properly calibrated to translate the signals from your internet connection.

Change The WiFi Frequency Band You’re Using

2.4 GHz and 5 GHz are the primary radio frequency bands used by modern routers. Based on how far you are from your router, the quality and speed of your connections can be affected by the band you select for your connections.

If you have interference on one of your frequency bands, consider shifting to another. A separate wifi network will appear on your device, with either 2.4 GHz or 5 GHz labeled in the network name. 2.4 GHz wifi connections are the most frequently used.

Many other wireless communications utilize this frequency. Therefore it can be a little congested at this time. While 5 GHz offers faster speeds but a longer range, this band is better at going through walls and other barriers. It is common for the two wifi networks to appear as two independent networks. Log out of the erroneous band and reconnect to the proper one on each device to re-arrange your connections.

Place Your Router In A More Convenient Location

Wireless signals can only travel so far before they are disrupted or blocked by walls, floors, ceilings, and all other significant physical objects. Cordless phones, microwaves, baby monitors, and Bluetooth speakers can also interfere with these signals.

Your wifi may not work at the other end of the house if you install your router in a corner. Your router should be placed in a central and elevated location, close to where you frequently use the internet. Keep your router out of the basement or the closet to avoid connectivity troubles.

Extend Your WiFi Network

A device that extends your network’s range may be necessary if your router is in the optimal place, but you’re still experiencing problems with speed or connectivity in some regions of your home. There are several devices you may use to expand your network’s reach, including:

• Wifi boosters can amplify or redistribute current wifi signals to the new location between your router and the dead zone.
• Like a wifi booster, wired access points connect to your router through an Ethernet cable and can spread wifi and LAN signals as an extension of your network. Many devices, including outdated routers, can be utilized as access points.
• Powerline extension kits have two devices: one that connects to your router through Ethernet and the other that plugs into an outlet. The internet signals pass through your electrical wire when you plug the second one in where you want stronger wifi.
• Mesh wifi systems replace your router with one or more devices that collaborate to form a single wifi network covering your entire house from numerous points.

While all of these can help you get more range out of your wifi, the optimal one for your network will be based on your house’s layout. A booster is a good option if you have just one obstinate dead zone. If your home is huge or has a complicated layout, mesh systems are the best option. It’s best to use an access point if your home is connected to Ethernet.

Adjust Your Router’s Antennas

It is common for routers and wireless access points to have inside antennae, so you cannot change them. Ignore the next step if that is the case. However, if your router has antennae that can be re-configured, do so.

Transmit and receive signals in all directions perpendicular to the antenna, as with most router antennas. For example, a horizontal wifi antenna transmits wifi signals vertically. Adjusting an antenna to sit horizontally and spread wifi signals up and down could help you extend your signals to numerous stories if you need to.

Why Hasn’t My WiFi Speed Increased When I Upgraded From 10 Mbps To 500 Mbps?

Any inexpensive 150Mbps N router will suffice for 10Mbps. Still, if you want to achieve the genuine 500Mbps connection, I’m guessing you’ll need a powerful wireless AC router and an AC-enabled device like a laptop or tablet. A high-speed AC router will not increase your internet speed beyond 433Mbps; it will be much lower in the actual world.

Even for a current $1100US Y50-70 laptop with the built-in AC adapter. Another major issue with wifi is that the farther you are from the router, the slower your connection will be. Because most PCs and laptops already have gigabit ethernet built-in, all you’ll need to enjoy 500Mbps via wire is a router with gigabit ethernet support. Getting 500Mbps over a wifi network is still a challenge for most devices.

Is Upgrading Internet Speed Worth It?

No, sort of, but still, YES. Everything depends on the time and speed at which you, we, or I start. Yes, switching from modem to ISDN at a cost more than twice as high (moving from a connect time of 10 seconds to 0.2 seconds and from 33.6kbit/s to 128kbit/s) was a no-brainer.

• It was likewise a no-brainer to go from ISDN at 128kbit/s to 512/512kbit/s ADSL at HALF the monthly cost.
• 512/512kbit/s of ADSL would be upgraded to 8/2Mbit/s for the same monthly fee. It wasn’t a problem; it was apparent.
• It converted from ADSL to 250/250Mbit/s optical fiber for a 40% monthly cost savings. That was an obvious choice.
• Increasing the speed from 250/250Mbit/s to 500/500Mbit/s at a 20% monthly cost increase. made little sense, but I’m worth it.
• Even though it only increased my monthly fee by 15%, doubling again to 1000/1000Mbit/s made no sense. However, it grants me some bragging rights, and I am worth it. Someone has to be a pioneer.

Does Higher Internet Speed Make A Difference?

The more quickly you download, the more data you may use; this is ideal for high-definition content, which needs a constant stream of downloads to ensure the best possible visual quality.

Conclusion

Let’s conclude the topic of What To Do After Upgrading Internet Speed? There are instances when your internet connection is too slow to handle the amount of data you’re consuming. This means that you’ll have to pay more for higher-speed internet service if that’s the case. It’s possible that even though you’ve paid for enough internet speed, your connection doesn’t always perform at 100%.

It’s not guaranteed that you’ll always get the advertised speeds from your Internet service provider. You may not always get the bandwidth you pay for, even if you have a 100 Mbps subscription. You may require a buffer or a speedier strategy than you expected. There will still be network issues, but they will be less noticeable.

Frequently Asked Questions